Skip to content

Plan a trip

Import a GPX or KML route as a stop

Import a route from Add stop: pick a GPX or KML file up to 10 MB and the trail draws on the map, with a duration worked out from its distance and climb.

3 min read Updated
On this page

Press Add stop, choose Import a route and pick the GPX or KML file your watch or app recorded, up to 10 MB. Treader makes a stop at the trailhead, draws the trail on the map and sets the stop's duration from the distance and the climb. It is on every plan. Fitting the day around a trail is in Plan a hiking trip, and the trip planning checklist covers the rest of the trip.

Import a route

  1. 1 In the itinerary, press Add stop and choose Import a route.
  2. 2 Pick a GPX or KML file. Treader reads it in your browser, so the file stays on your device. Only a simplified line is saved with the trip.
  3. 3 A new stop appears on the day you have open, pinned at the route's first point and named after the name inside the file, or the file name when there is none.
  4. 4 The trail draws on the map as a dotted line, apart from the solid routed legs between stops.

A file over 10 MB is refused with a note to export the track alone. A file with no track points, or fewer than two, shows "No route in that file" instead of a broken stop.

Attach or remove a route on an existing stop

Open a stop's detail and press + Attach a route. It works on any stop you can edit, except a flight or other journey leg and the ideas in the Ideas pen. Remove beside the route's name drops the line and keeps the stop as a plain pin. Attaching also sets the stop's duration from the file again; removing leaves the duration as it was.

Read the climb and the elevation profile

The stop's detail shows the route's distance and, when the file recorded elevation, the ascent and descent. Under them a profile draws height along the route, with the Low point, the High point and how far along the high point sits. Point at the line, or drag a finger along it, to read the distance and height at that spot. Heights read in metres, or in feet when your temperature unit is °F.

Ascent and descent ignore wobbles under 5 m, so a flat walk does not become a mountain. A file with no elevation shows distance only, and its duration counts distance alone. A route attached before profiles existed has none: Remove it and attach the file again.

Where the duration comes from

The duration is Naismith's rule: 12 minutes per kilometre plus 1 minute per 10 metres of climb, rounded to the nearest 5 minutes. Walking pace, in Settings under Map, scales it: Relaxed adds 25 percent, Brisk takes off 20 percent and Steady is the default. The number is set once, when you import or attach, so changing your pace later rewrites no stop you already have. To change one, edit the stop's time and duration.

The line saves with the trip, so everyone on the trip sees the route. The file itself, and anything else your watch recorded in it, stays on your device.

Tip

The duration is a walker's. Import a ride or a paddle and the stop says a walking time, so the day looks longer than it is. Set the real duration on the stop right after you import, then check the day in Organize each day of your itinerary.